Spaceslide

Now measure the overall aperture that you wish to install your wardrobe system into.

These measurements are very important, please measure the height in at least 4 places, at each end and 2 in between. The width in at least 3 places, top, bottom and along the centre line.

It is important to input only the SMALLEST dimension for both height and width. We will tailor make the system to fit these sizes, so you may have to use packing to the sides and top and bottom to level your aperture. As a guide the Height should be within 6mm overall and the width within 10mm.

If you propose using at least one end panel then input the smallest width dimension to the proposed position where the outside of the end panel(s) will be located.

If your required height exceeds our maximum of 2490mm you can choose to include height reducers in the form below.

If you need to use our height adjusters, please enter the proposed height after allowing for the adjusters. Note we are unable to supply precut facings to conceal the adjusters, however you can order an additional end panel Or liners to use in this area, which can be cut down with a standard fine woodsaw.