Spaceslide

 

How do I start?
Measure the area into which you want the system installed, if you are going to have drawer units and or Glass shelves make a sketch showing where they will be situated. If you are using the system inconjunction with doors make sure you have clearance to open the drawers!

Calculate from the dimensions listed below how much overall room is required to fix your choice of drawers and glass shelves. Remember to allow for the drawer units to open if you are also ordering Sliding doors. As a rough guide divide the aperture width by the number of doors if the result is less than 620mm you may have problems opening the drawer. Then calculate the width of the remaining area and decide which shelves and hanger bars are most economical to use and cut down in size if necessary, to create a perfect fit into your chosen area. Note the dimensions below are the size of each part, you need to allow for the stanchions which are 25mm wide. (FYI they are 75mm deep but this does not affect calculations)  

Then count up the total number of Stanchions required and the number of shelves, hanger bars, drawer units and create your quotation below.

The Apollo range of Storage system accessories are based around a Stanchion system. The minimum requirement is 2 Stanchions between which you fix a choice of options. All fixings to do this are included.

To increase the size of your Storage shelving system, add extra Stanchions as required. You can mix the 2 styles of Stanchion (Floor to wall or Floor to ceiling).

The Stanchions have channels in them into which you fix the bracket system supplied, to support a selection of Clothes Hanger Bars, Shelves and Drawer units.

Please note that you can not cut down a glass shelf or Drawer unit.

Hanger Bars and MFC shelves can be cut down in length to create a fitted furniture system.